Operation Manual

MC2+—User Guide
EN-22 121800
-4- Enter a configuration Name if required.
-5- Choose and enable the Target Modulati on if
required.
-6- Enter and enable the Upstream or Downstream
thresholds if required.
These settings determine whether the test will pass
or fail. All the enabled options must be satisfied for
the test to pass.
-7- Select the Apply button to save your settings.
The ADSL LED Configuration Choice page is
displayed.
-8- Choose the Configuration you want to use and
select the Apply button to save your choice.
The Save All page is displayed.
-9- Select the Save All button to confirm and wait for
MC2+ to save your settings.
You must now switch off MC2+ and restart to enable
your settings.
You can now disconnect MC2+ from the PC as the
configuration has now been saved on MC2+.
For information on the ADSL LED see ASDL Status
LED on page EN-6.
Enabled options
121800-7.book Page 22 Monday, October 20, 2008 4:11 PM