Operation Manual

Issue 7 - 10/08 EN-13
Using MC2+ when connected to a PC
English
DHCP Dynamic Host Control Protocol. When this option is
chosen it enables the MC2+ to receive an IP Address
automatically from the DHCP server. With dynamic
addressing, a device may have a different IP address
assigned each time it connects to the network. Choose
this option when no authentication is required.
Bridged You can configure MC2+ to simulate a bridged modem.
In Bridged mode, Ethernet frames are bridged over ATM
Virtual Circuits.The Ethernet frames are encapsulated
using either LLC Encapsulation or VC Multiplexing.
Because the Ethernet packets are bridged, the MC2+ only
has to pass the Ethernet packets to and from the ISP and
the local network. The IP Addresses of the local network
are assigned by the ISP either statically or dynamically.
Default Gateway The Default Gateway is a host to
which local computers send data that
is destined for non-local computers.
Enter the Default Gateway. This is
provided by your ISP.
DNS 1-3 The DNS service is used to translate a
Domain Name into a corresponding IP
Address.
Enter the Domain Name Services
values if provided by your ISP.
Mode Choose either
Bridged or Routed.
Static Settings
Description
DHCP Settings
Description
Encapsulation See Static Settings Table on page
EN 12.
IP Address If your DSL line is connected and your
DSL/ISP supports DHCP, select the
Renew button to retrieve these
settings.
Mask
Gateway.
Default Gateway
Bridged Settings
Description
Encapsulation See Static Settings Table on page
EN 12.
121800-7.book Page 13 Monday, October 20, 2008 4:11 PM