Operation Manual

MC2+—User Guide
EN-12 121800
Static This is used whenever a known static IP address is
assigned. The Subnet Mask and the Gateway should also
be entered. You can also specify up to three DNS
(Domain Name Server) addresses to enable access to
other web servers.The valid IP Address range is from
0.0.0.0 to 255.255.255.255.
Authentication This defines the authentication
protocol for your ISP. The default is
CHAP.
MTU Enter the Maximum Transmission Unit
for the DSL connection. The default is
1500.
On-Demand Select to enable on-demand
connectivity to the internet. Your
internet connection will be
disconnected if no activity is detected
after the specified timeout value. The
default is disable.
Default Gateway Enable to set this connection as the
default gateway in the routing table.
Enforce MTU PPPoE only.
Debug Select to enable PPP connection
debugging facilities.
PPPoE & PPPoA
Settings
Description
Static Settings
Description
Encapsulation LLC and VC are two ways of
encapsulating multiple sessions. If
you are not sure of the settings, leave
it as the default (LLC).
IP Address Enter the static IP address to be
assigned to the WAN interface on the
MC2+. This is provided by your ISP.
Mask The Subnet Mask is used to determine
the Subnet to which the IP address
belongs.
Enter the Subnet Mask to be assigned
to the WAN interface on the MC2+.
The Mask is provided by your ISP.
121800-7.book Page 12 Monday, October 20, 2008 4:11 PM