Operation Manual

MC2+—User Guide
EN-10 121800
Connection Controls Section
This section enables you to choose a WAN
Connection (see Testing an ADSL Line connection in
Stand-alone Mode on page EN-25.
Connect Select the Connect button to use the current settings
to establish a PPP connection. If On-Demand mode is
enabled the Connect button is disabled.
Disconnect See Disconnecting a Connection on page EN-27.
Configuring your MC2+
The following describes how to set up and save WAN
(Wide Area Network) connections; so that the MC2+
address, on the WAN (ADSL) side of the network,
matches the networks that you are going to test. For
details on setting up the LAN Configuration see
Setting up the LAN Configuration on page EN-16.
Setting up New WAN Connections
-1- From the HOME page select the SETUP button.
The WAN Setup page is displayed.
-2- Select New Connection from the WAN Setup
List.
WAN Setup List
121800-7.book Page 10 Monday, October 20, 2008 4:11 PM