Operation Manual

Issue 7 - 10/08 EN-7
Connecting MC2+ to a Power Supply
English
Connecting MC2+ to a Power Supply
MC2+ can be either battery powered or mains electricity
powered giving total flexibility for most testing sites and
situations. See Batteries on page EN-1 for more
information.
Fitting and Using Batteries
-1- Push the lower end of the tester out of its protective
rubber case.
-2- Remove the battery compartment cover.
-3- Insert 4 x AA batteries.
Warning
Make sure that you insert the batteries correctly.
-4- Refit the battery compartment cover.
-5- Refit the protective rubber case.
-6- Switch MC2+ on.
-7- Make sure that the Power LED is lit.
If the Battery Low Warning LED is lit, see
Batteries on page EN-1 for more information.
Fitting and Using the Mains Electricity Adaptor
-1- Push the mains adaptor supplied into the Mains
Adaptor Connector on MC2+.
-2- Connect the mains adaptor plug to a suitable mains
electricity socket.
-3- Make sure that the Power Indicator LED is lit.
Warning
The Mains Adaptor supplied with MC2+ is to be used
ONLY with MC2+ or with the charger supplied.
Any damage caused by misuse of the Mains Adaptor will
invalidate the warranty.
121800-7.book Page 7 Monday, October 20, 2008 4:11 PM