Operation Manual

Chapter 9
Tone generator
87
NOTE:
The Tone Mode remains enabled until you press Escape.
3. Use soft keys to select the wire pair (Pair 78, Pair 36, Pair 54 or Pair 12) into which
the tone signal is to be fed.
4. Press SHIFT to select tone signal and enable it with soft keys LOW, HIGH or
WARBLE.
9.1.2. Enable Tone Generator with Remote handset (RH)
1. Connect Remote handset (RH) to cable to be tested.
2. On Remote handset (RH) press TONE. The tone mode is enabled. The first line of
the two-line Remote handset (RH) display shows the message TONE. In the second
line, the type of tone signal as well as the feed location is shown in XY format.
X symbol
(Tone)
Y symbol
(feed location)
L = Low
78 = Pair 78
H = High
36 = Pair 36
W = Warble
54 = Pair 54
12 = Pair 12
Example: L78 = low tone ("Low"), pair 78
NOTE:
The Tone Mode remains enabled until you press Escape.
3. Select the wire pair into which the tone signal is to be fed by switching between
the options with the TONE key.
4. Select the tone signal for the selected wire pair by switching between the options
with <SHIFT>+TONE.