Operation Manual

Chapter 8
Fiber testing (LWL) FiberTEK™ FDX
81
3. Use soft key to open menu to designate and save the test portion.
4. Use Up/Down Arrow Keys to navigate between the boxes, and use
Alphanumeric keys to designate the test portion from/to.
5. Press Enter to save the entries. Use Escape to exit menu without making
changes.
8.10.2. Power Meter Mode
Use the power meter (PM) mode to measure light power and loss, if according preferences
are applied The test results can be saved and edited in IDEAL DataCENTER as "Power Meter".
1. Use Arrow Keys to navigate to menu Power Meter Mode and press Enter.
Illustration 8.10.2. Continuous Run
2. Use soft key Run to start continuous run of measurement until it is finished by
pressing soft key Stop.
3. Use soft key to open menu to designate and save the test portion.
4. Use Up/Down Arrow Keys to navigate between the boxes, and use
Alphanumeric keys to designate the test portion from/to.
5. Press Enter to save the entries. Use Escape to exit menu without making
changes.
8.10.3. Set Reference Value
Use soft key Set Ref. Value to define a value that can be used as reference for all
subsequent measurements.
Use soft key Toggle dBm to switch the unit between dBm (decibel-miliwatt) and mW
(miliwatt).
Use soft key Toggle Wavelength to open the menu to select the wavelength.
8.10.4. Light Source Mode
The FiberTEK FDX can be used as a source for other meters or devices. Wavelength is
adjustable and the source can be modulated for use with fiber identifiers.