Operation Manual

Chapter 5
Autotest
53
8. After completion of calibration and display of according message, press Escape to
return to main screen.
5.10. Perform Autotest
Autotest is performed after all preferences have been carried out.
1. Disconnect the cable line to be tested from all network components.
2. Using suitable patch cords, connect the Display handset (DH) to one end of the
cable line (link), and the Remote handset (RH) to the opposite end of the cable line
(link).
3. Start by pressing Autotest.
5.11. Open Job Folder of Autotest
The internal memory of LanTEK
®
II Cable Tester can hold a maximum of 1700 individual TIA
CAT-6 Autotest results with graphs, which can later be loaded again via File . The Autotest
results can be saved immediately after the test.
 The complete set of test results is saved in a file.
 The test results are automatically saved if Autosave option is enabled.
 Completed tests are automatically assigned a name. If another name is desired, the test
can be renamed via option Rename.
5.11.1. Job Options
1. Open "File" on start screen.
2. Use Arrow Keys to navigate to the desired job folder. The display is highlighted
yellow.
3. Use soft key to open job options.
Job Options
Description
Current Job Info
The display shows the total number of passed/failed tests, cable
length and memory used for the highlighted job folder.
All Job Info
The display shows the total number of passed/failed tests, cable
length and memory used for all highlighted job folders.
Permanently Delete Selected
Jobs
The selected job folder is deleted.
Rename Job
Renaming highlighted job folder.
New Job
Adding a new job folder to job list.
Make Job Current
Enables highlighted job folder. Autotests are now stored under this
job.
5.11.2. Test Options
1. Use Arrow Keys to navigate to the desired job folder. The display is highlighted
yellow.
2. Press Enter to display single tests.