Operation Manual

Chapter 5
Autotest
29
 The test results of the last Autotest remain in the non-volatile memory until they are
overwritten by new test results, the memory is deleted or an analysis test is conducted.
Overall Passed/Failed Result
The overall result of Autotest is displayed after test series is completed.
Symbol
Overall Autotest Result
The overall Autotest receives a passing grade if all single tests have been passed or
passed*.
The overall Autotest receives a failing grade if at least one single test has failed or
failed*.
5.1. Set Autotest Pref
1. Open "Preferences" on start screen.
2. In "Preferences" open Autotest Pref.
3. Use Arrow Keys to navigate to the according Autotest Pref. Use soft key
to enable or disable the selected Autotest Pref. Enabled Autotest Pref are indicated
by green boxes.
Illustration 5.1. Autotest Pref
4. Press Enter to save the information entered. Escape allows you to exit the menu
without making changes.
Autotest Pref
Description
Simple cable ID
Assign name to cable line and set/reset meter reading of tests. The name
can be assigned as simple cable ID or double cable ID (Cable From/Cable
To).
NOTE:
If Simple Cable ID is not enabled, the cable name assigned will be
the default cable ID. In addition to cable name and test meter, an
initial value and a final value can be set, and the way of counting
can be specified.
Stop on Fail
The Autotest is stopped after the first failed test.
Autosave
The LanTEK
®
II Cable Tester automatically names and saves all results of
passed Autotests in the current job folder.
Auto Increment
The test meter for the cable ID is automatically advanced after each
Autotest.