Operation Manual

FiberTEK III Document 164802 Iss 3
User Manual Page 3
Safety Precautions
WARNING!
NEVER look directly into the port of measuring adapter, at connector surface, open fiber ends or into couplers.
There is a risk of light emerging from the fiber that is not visible, which could permanently damage your eyes.
If you are not sure whether the device is switched on or whether the fiber transmits light, for safety reasons always
assume that the device is active.
Handle bare fibers properly; there is a risk of injury from fiber splinters.
Protect your eyes when working with bare fibers; fiber splinters could permanently damage your eyes.
Never let fiber scraps lie openly and never dispose of them loosely in normal waste containers; there is a risk of
injury from fiber splinters.
CAUTION!
When connecting the measuring adapter to a light-conducting line, the maximum measuring range must be
observed (see specifications of individual modules). Exceeding it could result in damages to FiberTEK™ III
modules.
NOTE:
Before connecting cable adapter to FiberTEK™ III adapter, ensure that the plugs of cable connectors are
clean.
Clean ferrules of measuring adapter only with dry, lint-free, non-abrasive materials.
The plugs can be cleaned with suitable fiber cleaning cloths or cleaning pens. IDEAL recommends
cleaning set #1219-00-1621025205 (2.5 mm) and 025204 (1.25 mm) to care for the modules and patch
cord.
Disclaimer
IDEAL INDUSTRIES, LTD. does not assume any liability for death, injury or damage to equipment or
property resulting from improper use of the battery packs.
IDEAL INDUSTRIES, LTD. will not be liable for consequential damages that may result from tampering
with the battery packs or charger or their use thereafter.
Subject to technical changes.
Environmental Protection
If you have any questions concerning these precautions, the operating instructions, or any other
concerns about the safe use and disposal of the battery packs used in LanTEK
®
III, please contact a
representative of IDEAL INDUSTRIES, LTD.