Operation Manual

FiberTEK III Document 164802 Iss 3
User Manual Page 22
Chapter 5. FiberTEK™ III Analyse Mode
The FiberTEK™ III selects the reference level and test limits based on the test selected. When testing
fibers (LWL), the remote handset (RH) must be manually powered on.
1. Set the cable parameters including the wavelength, and perform a field Calibration if necessary.
2. On the ready screen, select Analyse.
Fig. 15 Analyze
5.1.1 Continuous Run
This mode is used for troubleshooting. During continuous run, the measurement is repeated until it is
manually cancelled. There is no save function.
1. In the Analyze screen select Continuous Mode.
Fig. 16 Continuous Run (Ready)
2. Use soft key to start the test