User manual

57
CHAPTER 8
LanXPLORER Firmware Update
The LanXPLORER firmware should be updated at regular intervals. The latest firmware
update can be downloaded from the IDEAL INDUSTRIES Ltd Internet site.
If you register for the Newsletter on the IDEAL INDUSTRIES Ltd Internet site, you will be
notified of new downloads automatically.
The LanXPLORER firmware can be updated using as USB storage device.
NOTE:
Before updating the firmware, make a backup of the test data on the LanXPLORER.
When updating the firmware, power should be supplied to the LanXPLORER using the
charger/power pack or ensure that the rechargeable batteries are fully charged.
Data export and data import is accomplished exclusively to/from a USB storage device
connected to the LanXPLORER.
1. Store the firmware update on an empty USB storage device.
2. Plug the USB storage device into the USB interface on the LanXPLORER.
3. Switch on the LanXPLORER.
4. Ensure that the rechargeable batteries in the LanXPLORER are charged or
connect the LanXPLORER to mains power.
5. Select the menu point Setup.
6. Select the menu point "System".
7. Select the menu point "Update".
8. Update the software. You can exit the
menu without saving the changes with
Cancel or Escape.
9. Select "Confirm" to start the update.
10. Wait until the update has concluded and
the main menu appears on the
LanXPLORER display after restarting.
11. Remove the USB storage device.
NOTE:
Depending on the update, the LanXPLORER will re-start automatically or requires a manual
re-start.
Figure 54: Update