User manual

Chapter 6

Test Description and Procedure

6.12. Loop

This test allows measurement of the network transfer rate. In this test the LanXPLORER

serves as a reply box for a measuring instrument with active layer (up to stage 4) (e.g.

Trend Unipro or Trend Multipro).

The LanXPLORER can be set to one of the following types of loops, preset in the

instrument:

 Wireline

 Mac

 IP

 UDP

6.12.1. Performing test

1. Select Setup.

2. Set the type of loop specified by the measuring instrument with active layer.

3. Save the entry made with Apply. You can exit the menu without saving the

changes with Escape.

4. Select Run to start the test.

6.13. PC Diagnosis

With this test the LanXPLORER can provide information on the MAC and IP level of the

connected PC. Moreover information is output on data transfer (traffic).

1. Select the menu point "PC Diag".

2. Select Run to start the test.

Figure 51: PC Diagnosis