User manual

Chapter 5
Test Setup
37
5.3. Active wiring
This function allows all Ethernet-compatible devices to
be tested.
1. Select the menu "Ports" "RJ45".
2. Connect a network cable to the Ethernet-
compatible device to be tested.
3. Connect the free end of the cable path to
the RJ45 network port on the
LanXPLORER.
4. Select Detect to start recognition of the Ethernet-compatible device.
Item
Description
1
Line Rate and Duplex status (FD – Full
Duplex, HD – Half Duplex
2
Port number of compatible switch
3
Auto Negotiation On/Off
4
Recognition of power over Ethernet.
PoE - PoE present.
No-PoE - PoE not present.
5
IPv4 address
6
IPv6 address
Figure 33: Typical test setup for
an active cable path.
Figure 34: Active wiring test
1
2
3
4
5
6