Product Manual

Apr. 2019

UF-2200EH-X

c. Mount Power Unit to the Pedestal Control Stand assembly, using Bolts, Flat Washers & Lock Nuts ensuring

the Back Plate is already secured to the Stand.

d. Ensure to tighten all Nuts & Bolts for Pedestal Control Stand assembly.

3. Power Unit - (Filling Reservoir Tank)

a. Remove the red vent plug (Fig.2) from the power unit reservoir tank and fill

with hydraulic oil. Add oil until level reaches the Minimum fill line noted on

Reservoir Tank.

NOTE: Use Non-Detergent / Non-Foaming Hydraulic Oil - SAE-10, AW

32 or equivalent. The unit holds approximately six quarts of fluid. Make

sure the funnel used to fill the power unit is clean.

Fig.2

4. Control Panel Connections - (Power Unit, Release Valve & Latches)

a. Locate the Control Panel & Wiring Harness assembly (Figs.3 & 4) and carefully route Wiring Harness

through the backside of the Stand’s Back Plate lower left hand port, as shown in Fig.5.

Fig.3 Fig.4 Fig.5

b. Route Power Cord to the Power Unit’s Switch Box and make electrical connection, as detailed in Fig.6.

Fig.6