Product Manual

12
TP12KSC-DX
July 2018
FOUNDATION and ANCHORING REQUIREMENTS
Drill holes using 3/4” Clean hole. Run nut down just Tighten nut with
carbide tipped below impact section Torque wrench to
masonry drill bit per of bolt. Drive anchor 110 ft.-lbs.
ANSI standard into hole until nut and
B94.12.1977 washer contact base.
2.3 Tools & Equipment Required
· 12 quarts of Non-Detergent / Non-Foaming Hydraulic Oil - SAE-10, AW 32 or equivalent
· Chalk line and 12’ Tape Measure
· Concrete hammer drill with 3/4” bit
· 11/16” open end wrench
· 3/4” open end wrench
· Torque wrench
· 15/16” deep socket or wrench
· 1-1/8” socket
· 13/16” open end wrench
· Level (18” minimum length)
· Vise grips
· Tape measure
· Funnel
· Hoist or Forklift (optional)
· Two 12’ step ladders
· 1/4” drive ratchet with 5/16” socket
3-1/2”
3-1/2”
4-1/2”
4-1/2”