Product Manual

May 2019

TCWB-PSC206M-iDEAL

7. POSITION & INSTALLATION

1. Unscrew the nuts at the bottom, position the machine and

calibrate it with the horizontal rule. Mount the machine with

all the screws and to ensure the machine is stable. Make

sure the system is equipped with a good grounding circuit for

prevent electric leakage. And have operation range of ground

for skid prevention.

2. Unscrew the Nut (A) on the Cabinet Body (B) as shown in

Fig 3. Lift the Column (C) and mount it on the Machine Body

(B) by using the Nut (A) through the bolt located on the

machine Body (B). If the Column becomes loose after a

period of using, retighten them immediately. Otherwise, the

result of damage to the tire may occur.

Fig 4

8. ELECTRICITY & PNEUMATIC CONNECTIONS

CAUTION: Before installation and connection, check to be sure that the electricity

power supply corresponds to the machine technical data. All the installation of electric

and pneumatic devices must be operated by a professional electrician. Connect the

compressed air connector which is on the machine right side with compressed air

system. The electric grid that the machine connects to must have fuses protection

device and good outer cover grounding protection. Install the leakage automatic air

switch on the maim power supply, leakage current is set at 30mA.

CAUTION: No power plug for this machine, the user should self-connect one power

plug no less than 16A as well as in line with the machine voltage. Or directly connect

with the power supply according to the above requirements.