Product Manual

May 2019

TCWB-PSC206M-iDEAL

14.2 THE MAINTENANCE OF PROFESSIONALS

The maintenance of professionals can only be carried out by the professionals from the

factory.

14.2.1 If the imbalance value of tested wheel has obvious errors and does not

improve after self-calibrating, this proves the parameter in the machine has

altered, so the user should ask for professionals.

14.2.2 The replacing and adjustment of pressure sensor should be operated

according to the following methods, and the operation should be carried out by

professionals.

THE STEPS ARE AS FOLLOWS:

1. Unlash the No.1, 2,3,4,5 nuts.

2. Dismantle the sensor and nut.

3. Replace No.6, 7 the sensor organ.

4. Install the sensor and the nut according to the Fig 14-1. (Pay attention to the

sensor’s direction.)

5. Tighten No.1 nut emphatically.

6. Tighten the No.2 nut to make the main axis and the flank of cabinet, and then

emphatically tighten the No.3 nut.

7. Tighten the No.4 nut (not too emphatically), then tighten No.5 nut.

14.2.3 The replacing of circuit board and the sensor on it should be carried out by

professionals.

Fig 14-1