Product Manual

39
May 2019
TCWB-PSC206M-iDEAL
side display (Fig 7-9 left). Then slowly rotate wheel, when outside position indication
LEDs all light, (Fig 5-1 (11)), at the 12 o’clock position of rim inside, stick weights equal
to value shown on the right side display (Fig 7-9 right) . Rotate wheel by hand again,
when display shows “RUN ---”,move hand away to let wheel rotate. When both side
display are on, wheel stops and balancing is completed.
Fig 7-9
7.7 ALU-S MODE DATA INPUT METHOD & BALANCING OPERATION
Above three ALU modes may not be suitable for all structure rims. Balancing
performance is not good under above three ALU modes for some rims. Then ALU-S
mode can be adopted. Input rim data method as follows:
Press [MODE] key, to make ALU-S mode indication light on. Mode indication as
following figure:
As per Fig 7-8 or Fig 7-9, move scale to rim inside (aI position), measure rim inner
distance (aI) value, press [a-] or [a+] to input aI value.
Move scale further inside to aE position, measure distance aE value, press [b-] or [b+]
to input aE value.
Measure rim diameter at aI position, press [d-] or [d+] to input dI value.
Measure rim diameter at aE position, press [FINE] and [d-] or [d+] to input dE value.
Fig 7-8