Product Manual

38
May 2019
TCWB-PSC206M-iDEAL
7.5 ALU-2 MODE DATA INPUT METHOD & BALANCING OPERATION
Follow 7.2 to input rim data, press [MODE] key, mode indication as below figure, then
enter ALU-2 mode to balance wheel
Input rim data, manually rotate wheel, when display shows “RUN ---”, move hand away
to let wheel rotate. When display shows “STOP”, wheel stops and display shows data.
Slowly rotate wheel, when inside position indication LEDs all light, (Fig 5-1 (10)), at the
12 o’clock position of rim inside edge, stick weights equal to value shown on the left
side display (Fig 7-8 left). Then slowly rotate wheel, when outside position indication
LEDs all light, (Fig 5-1 (11)), at the 12 o’clock position of rim inside, stick weights equal
to value shown on the right side display (Fig 7-8 right) . Rotate wheel by hand again,
when display shows “RUN ---”, move hand away to let wheel rotate. When both side
display are on, wheel stops and balancing is completed
Fig 7-8
7.6 ALU-3 MODE DATA INPUT METHOD & BALANCING OPERATION
Follow 7.2 to input rim data, press [MODE] key, mode indication as below figure, then
enter ALU-3 mode to balance wheel.
Input rim data, manually rotate wheel, when display shows “RUN ---”, move hand away
to let wheel rotate. When display shows “STOP”, wheel stops and display shows data.
Slowly rotate wheel, when inside position indication LEDs all light, (Fig 5-1 (10)), at the
12 o’clock position of rim inside edge, clamp weights equal to value shown on the left