Product Manual

37
May 2019
TCWB-PSC206M-iDEAL
(11)) all light, stick weights equal to value shown on the left side display, at the 12
o’clock position of middle rim (Fig 7-5). Again manually rotate wheel, when display
shows “RUN ---”, move hand away to let wheel rotate. When both side display are on,
wheel stops and balancing is completed.
Fig 7-6
7.4 ALU-1 MODE DATA INPUT METHOD & BALANCING OPERATION
Follow 7.2 to input rim data, press [MODE] key, mode indication as below figure, then
enter ALU-1 mode to balance wheel.
Input rim data, manually rotate wheel, when display shows “RUN ---”, move hand away
to let wheel rotate. When display shows “STOP”, wheel stops and display shows data.
Slowly rotate wheel, when inside position indication LEDs all light, (Fig 5-1 (10)), at the
12 o’clock position of rim inside edge, stick weights equal to value shown on the left
side display (Fig 7-7 left). Then slowly rotate wheel, when outside position indication
LEDs all light, (Fig 5-1 (11)), at the 12 o’clock position of rim outside edge, stick
weights equal to value shown on the right side display (Fig 7-7 right) . Rotate wheel by
hand again, when display shows “RUN ---”, move hand away to let wheel rotate. When
both side display are on, wheel stops and balancing is completed.
Fig 7-7