Product Manual

May 2019

TCWB-PSC206M-iDEAL

7. RIM DATA INPUT METHODS & BALANCING OPERATION

7.1 THE POWER-ON STATE OF THE MACHINE

After the power-on of the machine, it starts initialization automatically. The initialization

will be finished after two seconds. The machine enters normal dynamic balancing

mode (clamp counterweights on the both rim edge) automatically, as in Fig 7-1, ready

for input data of rim.

Fig 7-1

7.2 DATA OF WHEEL INPUT METHOD FOR NORMAL DYNAMIC BALANCE MODE

AND WHEEL BALANCING OPERATION

7.2.1 After power is on, machine enters normal balancing mode, as below.

7.2.2 Input rim data: Move scale to make handle head touch rim edge inner

position as Fig 7-2, get value a, put back scale. Push [a-] or [a+] to input a value.

Fig 7-2

7.2.3 Input rim width: Get rim width data showing on rim, or measure rim width by

caliper, push [b-] or [b+] to input b value.

7.2.4 Input rim diameter: Get rim diameter data showing on rim, or measure rim

diameter by caliper, push [d-] or [d+] to input d value.

7.2.5 Balancing operation against normal dynamic balancing mode: Input rim

data, manually rotate wheel, when display shows “RUN ---”, move hand away to

let wheel rotate. When display shows “STOP”, wheel stops and display shows