Product Manual

11
May 2019
TCWB-PSC206M-iDEAL
9.3. MOUNTING TIRE
CAUTION: Check to make sure that the tire and the wheel rim are of same size before
mounting the tire.
To avoid any damage on type, lubricate the tire bead and the wheel rim with the
lubrication recommended by manufacturer. Put on the tire and check the situation.
CAUTION: When clamp the wheel rim, don’t put your hands on the wheel rim to avoid
injury during this operation.
Lock the Hexagonal Vertical Mounting Arm, put the
tire on the rim, let the Rocker Arm back to place as
demounting the tire. And let one side of tire down
bead above the rear section of the Mounting /
Demounting head, the other side under the front
section of the Mounting/demounting head. Suppress
the tire with hands or help arm, and then spin the
turntable for mounting the tire down bead. Repeat
the above operation for mounting the tire up bead, as
shown in Fig 7.
Fig 7
10. INFLATING TIRE
IMPORTANT: It is very dangerous during inflating operation, take carefully and comply
with instruction. When inflating, it will turn to be extremely dangerous if problems
happen to tire or rim. The possible burst force tire goes upward and outward, the big
power may cause injury or death of the operator or the people around.
TIRE MAY BURST CAUSED BY FOLLOWING:
1. The wheel rim and the tire are not of the same size.
2. The tire or the wheel rim is damaged.
3. The pressure of tire inflation is over the max pressure recommended by
manufacturer.
4. The operator failed to comply with the safety regulations.