Product Manual

May 2019

TCWB-PSC206M-iDEAL

9.2. DEMOUNTING THE TIRE

Ensure to remove all the weights on the wheel rim and to exhaust the air in the tire

completely before this operation. Apply lubricating grease (or similar lubricant) around

the tire bead. Without the lubricant may lead to badly wear and tear on tire.

Clamp the wheel methods shown as below regarded to the ruled dimension:

a- to clamp the wheel from outside:

Tread the Jaws open and close Pedal (V) halfway down to middle, positioning for the

four jaws (G) by reference scale on the Turntable (Y); put the tire on turntable, hold the

rim, and tread the Jaws open and close Pedal (V) until the wheel is secured by the

jaws.

b- to clamp the wheel from inside:

Positioning for the four jaws (G) and let them all closed. Put the tire on the turntable

and tread the Jaws open and close Pedal (V) to open the jaws thereby lock the wheel

in place.

CAUTION: Check to make sure the wheel firmly secured by the four jaws before next

step.

Lower the Vertical Arm (M) until the Mounting/

demounting head (I) rests next to the edge of the rim,

flip the Locking Handle to lock the Vertical Arm and

Swing Arm in position, and also adjust the Rocker

Arm make Mounting/demounting head can raise

2mm-3mm automatically from the edge of the wheel

rim. Insert the Lifting Lever (T) between the tire bead

and the front section of the mounting/demounting

head (I), and move the tire above the mounting /

demounting head as shown as Fig 6.

Fig 6

CAUTION: Chains, bracelets, loose clothes and anything else close to the rotating

parts will bring danger to the operator.

With the Lifting Lever held in position, tread the Turntable Rotation Pedal (Z), rotate the

Turntable (Y) in a clockwise direction until the tire is completely separated from the

wheel rim. For the other side tire demounting, keep using the lifting lever to lift the tire,

make the other side tire separated from the wheel rim.