Product Manual

iDEAL Paint Spray Booth (PSB-SEMIDD26ASY-A)
23
4.10 TUBEAXIAL FAN
The fan and motor assembly bolts to the top of the Exhaust Chamber.
(Optional mounting flange ring may be required)
4.11 OPTIONAL - EXHAUST DUCT KIT & INSTALLATION
If equipped with optional exhaust ductwork, it is recommended to
have this professionally installed.
(Storm Collar & Roof Flange sold separately)
To assemble the ductwork:
1. Bolt pipe with connecting ring to the exhaust fan.
2. Remaining ductwork is crimped on one end to interlock with
the nextsection.
3. Your ARV (automatic damper) will be mounted on top.
4. Storm collar will attach to duct above flashing to make it
weather proof.
Special Note:
Where more than 25 ft. of piping is required, static pressure
(resistance) is increased and the air flow may be hindered when
using the standard exhaust unit recommended for use with the
booth. Where a piping arrangement of an unusual nature is
necessary or where two or more elbows are used, a similar condition
may exist. Therefore, if either ofthese situations arises, contact iDEAL
Rep. for recommendations. Exhaust piping, including the canopy (if
used), should extend a minimum of 6’ ft. above the highest point of
building. There should be an access door just above exhaust unit and
another just below each elbow.