Product Manual

iDEAL Paint Spray Booth (PSB-SDD26ASY-A)
15
K
C
0
1
K
C
0
3
K
C
0
4
K
C
0
5
Exhaust Filter Grid(s) Installation:
Small ‘End’ Filter Grid Sections
1. Using #8 drill screws screw a 40” angle (KC02) to the top of the opening.
2. Screw a 19-3/4” angle (KC03) to both ends of the opening.
3. Screw a 40” angle (KC02) between the two side angles at the bottom of the opening.
4. Place a 2”x19-3/4”flat strip (KC04) vertically in the center of the opening and screw in place from the
backside of the frame.
5. Place a 2”x40” flat strip (KC06) horizontally in the center of the opening and screw in place from the
backside of the frame.
6. Cut a piece of the roll blanket filter to fit opening and push in place.
Large ‘Center’ Filter Grid Section
1. Using #8 drill screws screw a 100” (KC01) angle to the top of the opening.
2. Screw a 19-3/4” angle (KC03) to both ends of the opening.
3. Screw a 100” angle (KC01) between the two side angles at the bottom of the opening.
4. Place 4 each 2”x19-3/4” flat strips (KC04) vertically on 20” centers in the opening and screw in place
from the backside of the frame.
5. Place a 2”x100” flat strip (KC05) horizontally in the center of the opening and screw in place from the
backside of the frame.
6. Cut a piece of the roll blanket filter to fit opening and push in place.
K
C
0
3
K
C
0
4
K
C
0
6
K
C
0
2
BOOTH
INSIDE
BOOTH
OUTSIDE
BOOTH INSIDE
BOOTH
OUTSIDE