Product Manual

iDEAL Open Front Paint Spray Booth (PSB-AFOFB1388-AK)

4.10 TUBEAXIAL FAN

The fan and motor assembly bolts to the top of the Exhaust Chamber Roof Panel

4.11 OPTIONAL - EXHAUST DUCT KIT &INSTALLATION

If equipped with optional exhaust ductwork, it is recommended to

have this professionally installed.

(Storm Collar & Roof Flange sold separately)

To assemble the ductwork:

1. Bolt pipe with connecting ring to the exhaust fan.

2. Remaining ductwork is crimped on one end to interlock with

the nextsection.

3. Your ARV (automatic damper) will be mounted on top.

4. Storm collar will attach to duct above flashing to make it

weatherproof.

Special Note:

Where more than 25 ft. of piping is required, static pressure

(resistance) is increased, and the air flow may be hindered when

using the standard exhaust unit recommended for use with the

booth. Where a piping arrangement of an unusual nature is

necessary or where two or more elbows are used, a similar condition

may exist. Therefore, if either ofthese situations arises, contact the

iDEAL Rep. for recommendations. Exhaust piping, including the

canopy (if used), should extend a minimum of 6’ ft. above the

highest point of building. There should be an access door just above