Product Manual

22
MSC-18K-X
May 2019
Monthly:
· Test the emergency stop button on all columns. Columns should stop immediately.
· Check the battery charging cables and cable ends.
· Inspect communication cables and cable ends for wear or damage.
· Check oil levels in hydraulic pump tank. Add oil on necessary.
Annually:
· Have an ALI Certified Lift inspector check all of your vehicle lifts and the safety systems for
wear or damage.
6. Service
CAUTION! If you are not familiar with vehicle lift service procedures, do not attempt repairs and
contact the factory/distributor for assistance. Use only experienced lift service technicians to perform
lift service.
Before and vehicle lift is serviced, follow the proper procedure for lock / out tag / out below.
Rules for Using Lockout Procedure
Use the Lockout Procedure whenever the lift is being repaired or serviced, waiting for repair when
current operation could cause possible injury to personnel, or for any other situation when
unintentional operation could injure personnel. No attempt shall be made to operate the lift when the
energy isolating device is locked out.
Purpose
This procedure establishes the minimum requirements for the lockout of energy that could cause
injury to personnel by the operation of lifts in need of repair or being serviced. All employees shall
comply with this procedure.
Responsibility
The responsibility for assuring that this procedure is followed is binding upon all employees and
service personnel from outside service companies (Installers, contactors, service repairmen). All
employees shall be instructed in the safety significance of the lockout procedure by the facility
owner/manager. Each new or transferred employee along with visiting outside service personnel shall
be instructed by the owner/manager (or assigned designee) in the purpose and use of the lockout
procedure