Product Manual

21
MSC-18K-X
May 2019
4.2 Operation
5. Connect all communication cables as show in Fig. 3.3
6. Turn on all the battery switches on columns. Then turn on all the power switch with the master
one in the last.
7. Depress the “UP” button and let columns rise approx. 6 inches. Release the “UP” button and
inspect all of the columns to insure that the lifting arms are positioned properly.
8. Depress the “UP” button again and raise the vehicle to the desired height.
Note: During the raising process you may notice one or more columns slow or stop lifting momentary.
This occurs when the lift control system is synchronizing each column to maintain level lifting.
This is normal.
9. After reaching to the desired height, press the “PARK” button. All lift columns will lower to the first
available safety lock position. When the lifts have settled onto the safety locks release the “Lock”
button. The vehicle is now safe and secured and ready for service.
10. To lower the lifts, check that all tools and equipment and has been removed from under the
vehicle. Press and hold the “DOWN” button. The lift will rise for a few seconds to allow the
safety lock disengaged. Then the lifts will lower down.
11. Before moving out the vehicle, move away all the columns from under the vehicle wheel first.
12. After finished one day’s work, turn off the power switch, disconnect the communication cables,
move the columns to the charging bay for charging.
5. Maintenance Instructions
CAUTION! If you are not familiar with vehicle lift maintenance, do not attempt repairs and contact the
factory/distributor for assistance. Use only experienced lift service technicians to perform lift
maintenance.
Daily:
· Check hydraulic system for leaks.
· Check the safety lock mechanism.
· Check communication cables for damage
· Inspect lifting arms to ensure they are in proper location & engaged in the locks.