Product Manual

MSC-18K-X

May 2019

To charge the battery, if necessary. A battery charger is built into each column. Plug the battery

charger power supply cord into a 110 volt grounded electrical outlet. Charge each mobile column lifts

using a separate electrical outlet. Best performance will be obtained by charging all mobile column

batteries at the same time. While charging, the red CHARGING lamp will be lighted. After the

batteries are fully charged (about 10 hours), this red lamp will be off and the green FINISHED lamp

will be lighted

When the lifts are new, charge the batteries for the first time approx. 12-15 hours or until the charging

indicator light turns green. Battery charging after 20-30 cycles will typically take 6-8 hours. When the

batteries are fully charged, disconnect the electrical cable and store in the charger bay.

To install the communication cable reels, first insert the reel holding frame into the base on the

upper cover of the column. Then fix the reel on the base by screws. Plug the communication cable

end into the socket on that specific column.

Please Note the Important Safety Information below for use of Extension Cords:

An extension cord should not be used unless absolutely necessary. Use of improper extension

cords could result in a risk of fire or electric shock. If extension cords must be used, make sure the

following safety precautions are observed.

· That the pins of plug of the extension cord are the same number, size and shape of those of the

plug on the battery charger.

· That the extension cord is properly wired and in good electrical condition.

· That the wire in the extension cord is proper size as recommend below.

Minimum recommended wire size for various length extension cords used with each battery

charger:

Length of Cord 25' 50' 100'

Cord Gauge 16 Gauge 14 Gauge 12 Gauge

· Do not operate the battery charger with a damaged cord or plug.

· Do not operate the battery charger if it has received a sharp blow, been dropped or otherwise

damaged in any way.

· Do not disassemble the charger. Incorrect reassembly may result in a risk of electric shock or fire.

· To reduce the risk of electric shock, unplug the charger from outlet before attempting any

maintenance or cleaning. Disconnecting the leads will not reduce this risk.

· To reduce the risk of shock or spark, never touch the ring terminals together while the charger is

plugged into an outlet or extension cord.

· External connections to the battery charger shall comply with all local, state, and federal

regulations.