Installation Guide
Patent No. US 8,856,780 CA 2759622
B1B1
C1C1
1
2
3
4
A1A1
CONNECT TO MODULE
NOTE
STEP 3
TYPE 1 - WIRING DIAGRAM - 1 OF 1
BRAKE HARNESS
RELAY
RELAY
C2 HARNESS
B2 HARNESS
C1 CONNECTOR
B1 CONNECTOR
BRAKE SWITCH
CONNECT THE FOLLOWING TO THE VEHICLE
START THE VEHICLE WITH THE OEM KEYFOB
TO TEST THE CONNECTIONS
WHITE 18 PIN
WARNING: THE ADAPTER CABLE IS NOT REQUIRED
BLACK 4 PIN
BLACK 6 PIN
WARNING:
THESE CONNECTORS
HAVE TWO [2X] LOCKING
MECHANISMS.
INSERT THE CONNECTOR
IN ITS HOUSING AND
APPLY GENTLE PRESSURE
ON BOTH EXTREMITIES
TO SECURE THE
CONNECTION. (TWO AUDIBLE
CLICKS WILL BE HEARD.)
MODULE
MODULE
BLACK 20 PIN
STEP 1
STEP 2
1-TO CONNECT THE MODULE: FOLLOW STEPS 1 TO 3
2-TO DISCONNECT THE MODULE: FOLLOW STEPS 3 TO 1
WARNING
07 GRAY/WHITE - HOOD STATUS (-) INPUT
08 GRAY/BLACK (NOT USED)
WHITE 10 PIN
IF NOT EQUIPPED
WITH AN OEM HOOD SWITCH,
INSTALL AN AFTERMARKET HOOD SWITCH
CONNECT IF REQUIRED
HOOD SWITCH
MINI: BEHIND INSTRUMENT PANEL, DRIVER SIDE
BMW: UNDER DASH, DRIVER SIDE
COMFORT ACCESS SYSTEM MODULE
IF THE MODULE HAS (1) RED CONNECTOR:
CONNECT THE JUMPER CABLE.
IF THE MODULE HAS (2) RED CONNECTORS:
DO NOT CONNECT THE JUMPER CABLE.
www.idatastart.comAutomotive Data Solutions Inc. © 2019 IDSIIDSRSBM1CMBMXA0EN
PAGE 7 OF 20
• 20190703
DOC.: #64342