Owner's Manual

Table Of Contents

ADS-RR(SR)-WJL1-DS-IG-EN maestro.idatalink.com

Jeep WranGler Jl 2018-2022

Fig. 1.3

Fig. 1.5

Fig. 1.4

Fig. 1.6

Fig. 1.1 Fig. 1.2

Fig. 1.9

Fig. 1.8Fig. 1.7

NOTE: Shallow mount radio required.

Backup camera is NOT retained.

DASH DISASSEMBLY

1. Using a panel tool, carefully pry outward on the climate

control panel to release the clips securing it in place. Then

disconnect the wiring harnesses from the back. (Fig. 1.1)

2. Remove the two (2) Phillips screws at the base of the radio

trim. Then, using a panel tool, pry outward to release the

clips securing it in place. (Fig. 1.2)

3. Remove the four (4) Phillips screws securing the radio

into the dash. Remove the factory radio from the dash.

Disconnect the main wiring harness, antenna connections,

and USB from the back. (Fig. 1.3)

4. Remove the one (1) Phillips screw securing the lower dash

panel. Then, using a panel tool, pry outward to release the

clips securing it in place. Disconnect the wiring harnesses

and USB connections from the back. (Fig. 1.4)

5. Open the glove box, press the upper stop up to allow the

glove box to pass it. (Fig. 1.5)

Then slide the control arm forward and out to release it

from the left side of the glove box. (Fig. 1.6)

Firmly pull outward on the glove box to release the lower

clips securing it to the vehicle.

DASH KIT ASSEMBLY

6. Secure the metal mounting brackets to the radio using the

hardware supplied with the aftermarket radio. (Fig. 1.7)

Ensure radio lines up ﬂ ush with the front WJL1 bezel by

temporarily placing it over the radio/brackets.

7. Remove the factory media hub by pressing down on the

four (4) clips holding it into the lower dash panel. Slide it

out the front of the panel. (Fig. 1.8)

8. Install the media hub adapter into the lower dash panel,

making sure the clips snap into place. (Fig. 1.9)

INSTALLATION INSTRUCTIONS P1 /2