Owner's Manual

Table Of Contents
ADS-RR(SR)-MFT1-DS-IG-EN maestro.idatalink.com
Ford EScapE with MyFord touch with Sony aMp without parking aSSiSt 2013-2016
Automotive Data Solutions Inc. © 2021
3
Fig. 1.7
Fig. 1.3
Fig. 1.5
Fig. 1.4
Fig. 1.6
Fig. 1.1 Fig. 1.2
DASH DISASSEMBLY
NOTE: If you are installing a standard sized double din
radio, trimming is required to make the radio fi t.
1. Using a plastic pry tool, remove the upper trim by pulling
upward. (Fig. 1.1)
2. Remove the two (2) 7mm screws from the radio bezel. (Fig.
1.2)
3. Unclip and remove the radio bezel by prying with a plastic
panel too. Unplug the connector from the panel and set it
aside. (Fig. 1.3)
4. Remove four (4) 7mm screws securing the screen. Unplug
and remove the screen. (Fig. 1.4)
5. Remove two (2) 7 mm screws securing the radio module.
Unplug and remove the radio. (Fig. 1.5)
6. Remove (4) 7mm screws securing the radio mounting
hardware. (Fig. 1.6)
7. If you are installing a standard sized double din radio, trim
the plastic behind the screen to make the radio fi t. (Fig. 1.7)
Keep screws and brackets for MFT1 dash kit assembly.
Unbox MFT1 dash kit and locate bracket set #1, discard
set #2.
INSTALLATION INSTRUCTIONS
2