Owner's Manual

ADS-RR(SR)-MFT1-DS-IG-EN maestro.idatalink.com
Ford F SupEr duty with MyFord touch without aMp 2017-2020
Automotive Data Solutions Inc. © 2021
4
Fig. 2.0
A B C
INSTALLATION INSTRUCTIONS
DASH KIT ASSEMBLY
1. Attach the brackets supplied with the MFT1 to the
aftermarket radio (use set #1 or #2, see previous page).
2. Remove the mounting brackets from the OEM screen and
attach them to MFT1 brackets (Example: Fig. 2.0).
3. Clip MFT1 panel on to the front of MFT1 brackets.
Media port adapter
4. Remove OEM Media port and connect MFT1 media port
adapter to aftermarket radio. If OEM media port is larger
than MFT1 media port, insert the supplied adapter plate,
then install MFT1 media port.
(Side view)
A: MFT1 bracket
B: OEM radio bracket
C: Aftermarket radio
MAKE CONNECTIONS (refer to wiring diagram)
1. Locate the aftermarket radio’s main harness. Cut the
WHITE, GRAY, GREEN and PURPLE RCA tips. Connect the
wires from the aftermarket radio’s main harness to the
MFT1 T-harness and match the wire functions (refer to
diagram).
2. Connect the MFT1 T-harness to the factory radio harness.
3. Connect all harnesses to the Maestro RR module.
4. Plug the aftermarket radio harnesses into the aftermarket
radio. Plug the data cable to the data port of the
aftermarket radio. Insert the audio cable into the iDatalink
3.5mm audio jack of the aftermarket radio (labeled
iDatalink. If there is no iDatalink audio input, connect to
AUX). Plug the backup camera RCA into the aftermarket
radio (if applicable).
Note: When using a Pioneer radio, please ensure that there
is nothing plugged into the W/R port of the radio.
5. Insert the radio and MFT1 kit in the dash, then test your
installation.
1