Owner's Manual

Table Of Contents
ADS-RR(SR)-MFT1-DS-IG-EN maestro.idatalink.com
Ford F SupEr duty with MyFord touch without aMp 2017-2020
Automotive Data Solutions Inc. © 2021
3
Fig. 2.0
Fig. 4.0
Fig. 3.0
Fig. 5.1
Fig. 5.0
Fig. 1.0
A
B
C
Fig. 1.1
INSTALLATION INSTRUCTIONS
DASH DISASSEMBLY
1. If the vehicle is equipped with a center channel speaker:
Pop the speaker grille up (A), unscrew (2) 7mm bolts from
the tray (B), and remove it (C). (Fig. 1.0)
If there is no center channel speaker: lift the rubber mat at
the top of the dash (A), then remove (2) 7mm bolts from the
tray (B), and remove it (C). (Fig. 1.1)
2. Remove the (2) 7mm bolts from the top of the radio panel.
Unclip the radio bezel, unplug its connectors, and remove
the panel. (Fig. 2.0)
3. Remove the 7mm screws securing the factory screen and
disconnect it. (Fig. 3.0)
4. Remove the (4) 7mm screws securing the radio module,
then unplug and remove it. (Fig. 4.0)
5. If using a shallow depth radio skip this step. If a camera
module is present remove the (3) 10mm nuts securing it.
(Fig. 5.1) Relocate the camera module to the location where
the factory radio body was, secure with tie wraps.
Looking down, from the top of the dash, locate the (2) 8mm
bolts securing the camera module’s bracket and remove
them. Remove the (2) 7mm bolts under the plastic of the
top of the dash (bolts aren’t visible).
Work the metal bracket free from the sub-dash and remove
it. (Fig. 5.1)
Note: the bracket may be cut but this will prevent
reinstalling OEM equipment.
Keep screws and brackets for MFT1 dash kit assembly.
Unbox MFT1 dash kit and locate bracket set #2, discard
set #1.
1