Owner's Manual

Table Of Contents

ADS-RR(SR)-FOC1-DS-IG-EN maestro.idatalink.com

Ford Focus with 8" MyFord touch screen and base audio systeM 2015-2018

Fig. 2.3

Fig. 2.5

Fig. 2.4

Fig. 2.1

Fig. 3.2Fig. 3.1

Fig. 2.2

INSTALLATION INSTRUCTIONS

MAKE CONNECTIONS (refer to wiring diagram)

1. Locate the aftermarket radio’s main harness. Cut the

WHITE, GRAY, GREEN and PURPLE RCA tips. Connect the

wires from the aftermarket radio’s main harness to the

FOC1 t-harness and match the wire functions (refer to

diagram).

2. Connect the FOC1 T-harness to the factory radio harness.

Plug the backup camera cable into the factory harness (if

applicable).

3. Connect all harnesses to the Maestro RR module.

4. Plug the aftermarket radio harnesses into the

aftermarket radio. Plug the data cable to the data port

of the aftermarket radio (port labeled iDatalink). Insert

the audio cable into the iDatalink 3.5mm audio jack of

the aftermarket radio (labeled iDatalink. If there is no

iDatalink audio input, connect to AUX). Plug the backup

camera RCA into the aftermarket radio (if applicable).

Note: When using a Pioneer radio, please ensure that there

is nothing plugged into the W/R port of the radio.

5. Insert the radio into the dash and secure the metal

brackets with (4) T25 screws. (Fig. 3.1)

6. Connect all the harnesses to the FOC1 kit, and secure it

in the dash. Test your installation before completely re-

assembling the bezel to the vehicle. (Fig. 3.2)