Owner's Manual

Table Of Contents

ADS-RR(SR)-FOC1-DS-IG-EN maestro.idatalink.com

Ford Focus with 8" MyFord touch screen and base audio systeM 2012-2014

Fig. 2.2

Fig. 2.4Fig. 2.3

Fig. 2.1

Fig. 3.2Fig. 3.1

INSTALLATION INSTRUCTIONS

MAKE CONNECTIONS (refer to wiring diagram)

1. Locate the aftermarket radio’s main harness. Cut the

WHITE, GRAY, GREEN and PURPLE RCA tips. Connect the

wires from the aftermarket radio’s main harness to the

FOC1 t-harness and match the wire functions (refer to

diagram).

2. Connect the FOC1 T-harness to the factory radio harness.

Plug the backup camera cable into the factory harness (if

applicable).

3. Connect all harnesses to the Maestro RR module.

4. Plug the aftermarket radio harnesses into the aftermarket

radio. Plug the data cable to the data port of the

aftermarket radio (port labeled iDatalink). Insert the

audio cable into the iDatalink 3.5mm audio jack of the

aftermarket radio (labeled iDatalink. If there is no iDatalink

audio input, connect to AUX). Plug the backup camera RCA

into the aftermarket radio (if applicable).

5. Insert the radio into the dash and secure the metal

brackets with (4) T25 screws. (Fig. 3.1)

Note: When using a Pioneer radio, please ensure that there

is nothing plugged into the W/R port of the radio.

6. Connect all the harnesses to the FOC1 kit, and secure it

in the dash. Test your installation before completely re-

assembling the bezel to the vehicle. (Fig. 3.2)