Owner's Manual

ADS-RR(SR)-CHK1-DS-IG-EN maestro.idatalink.com
JEEP CHEROKEE 2019
Automotive Data Solutions Inc. © 2019
4
INSTALLATION INSTRUCTIONS
MAKE CONNECTIONS
STEP 9
• Unbox the aftermarket radio and locate its main harness.
• Connect the wires shown on the next page from
aftermarket radio main harness to the CHK1 T-harness
and match the wire functions.
STEP 10
• Determine if the vehicle has a factory amplifi er. Look for
badges on the radio, door panels and dash that indicate the
presence of an amplifi er (ex: Alpine).
If the vehicle DOES NOT have a factory amplifi er:
• Plug the female GREEN connector to the male GREEN
connector of your CHK1 T-harness.
• Plug the female WHITE connector to the male WHITE
connector of your CHK1 T-harness.
If the vehicle DOES have a factory amplifi er:
• Plug the female GREEN connector to the male WHITE
connector of your CHK1 T-harness.
• Plug the female WHITE connector to the male GREEN
connector of your CHK1 T-harness.
STEP 11
• Connect the factory harness to the CHK1 T-harness.
STEP 12
• If using a T-harness VER_1.6 or earlier, cut and remove
the OBDII connector from the cable. Connect Red/Brown
wire to vehicle CANH and Yellow/Brown to vehicle CANL,
located at CAN junction connector.
• If using a T-harness VER_1.7 and up, plug the white
connectors into the vehicle’s can junction, located behind
glove box.
STEP 13
• Plug the aftermarket radio harnesses into the aftermarket
radio.
• Plug the Data cable to the data port of the aftermarket
radio.
• Insert the Audio cable into the iDatalink 3.5 mm audio
jack of the aftermarket radio (If there is no iDatalink audio
input, connect to AUX).
Note 1: On Pioneer radio, ensure that there is nothing
plugged into the W/R port.
Note 2: If the vehicle is equipped with parking sensors
AND using an Alpine radio: plug Audio cable in auxiliary
input of the radio.
STEP 14
• Connect all the harnesses to the Maestro RR module.
• If the vehicle is equipped with OEM parking assist, lane
departure, or other safety systems, the ACC-SP1 is
required: Plug the ACC-SP1 the Maestro RR.
If you are not using this speaker, the radio will mute when
the parking assist is active. If you are using this speaker,
the parking assist chimes will play through the external
speaker and the radio will not mute unless the settings
are changed in the radio.
STEP 15
• Install the CHK1 dash kit and test your installation.
2