Owner's Manual

ManualsBrandsiDatalink ManualsAudio accessories & installationDash and Wiring Kit

Table Of Contents

ADS-RR(SR)-CAM1-DS-IG-EN maestro.idatalink.com

Chevrolet Camaro without amP 2010-2015

Fig. 2.4 Fig. 2.5

Fig. 2.1

Fig. 2.3

Fig. 2.2

Fig. 2.4 Fig. 2.5

Fig. 2.1

Fig. 2.3

Fig. 2.2

Fig. 2.4 Fig. 2.5

Fig. 2.1

Fig. 2.3

Fig. 2.2

INSTALLATION INSTRUCTIONS

RADIO INSTALLATION/MAKE CONNECTIONS

Unbox the aftermarket radio. Install the metal brackets

provided with the CAM1 kit to the aftermarket radio using

the screws supplied with the aftermarket radio. (Fig. 2.3)

(refer to wiring diagram)

1. Locate the aftermarket radio’s main harness. Cut and

remove the speaker wire junction connectors. Connect the

wires from the aftermarket radio’s main harness to the

CAM1 t-harness and match the wire functions

2. Plug the backup camera cable into the factory harness (if

applicable).

DASH DISASSEMBLY (Radio removal)

1. Remove (2) 7mm screws securing the bottom of the radio

bezel. (Fig. 2.1)

2. Using a panel tool, gently release the clips securing the

radio bezel to the dash. Disconnect the wiring harness on

the back of the OEM panel. (Fig. 2.1)

3. Remove (4) 7mm screws holding the OEM radio in the dash.

Unclip the radio and remove it. (Fig. 2.2)

3. Connect the CAM1 T-harness to the factory radio harness.

4. Plug the OBD2 connector into the OBD2 port of the vehicle,

located under the driver side dash.

5. Plug the aftermarket radio harnesses into the aftermarket

radio. Plug the data cable to the data port of the

aftermarket radio. Insert the audio cable into the iDatalink

3.5mm audio jack of the aftermarket radio (labeled

iDatalink. If there is no iDatalink audio input, connect to

AUX). Plug the backup camera RCA into the aftermarket

radio (if applicable).

Note: When using a Pioneer radio, please ensure that there

is nothing plugged into the W/R port of the radio.

6. Connect all harnesses to the Maestro RR module.

7. Insert the radio into the dash and secure the metal

brackets with (4) 7mm screws removed during disassembly.

(Fig. 2.4)

8. Connect the white 6-pin harness to the button bar of the

dash kit.

9. Press the CAM1 bezel into place and secure it with the (2)

7mm screws. Test your installation before completely re-

assembling the vehicle. (Fig. 2.5)