Owner's Manual

ADS-RR(SR)-CAM1-DS-IG-EN maestro.idatalink.com
Chevrolet Camaro without amP 2010-2015
Automotive Data Solutions Inc. © 2019
3
Fig. 1.7
Fig. 1.9
Fig. 1.8
Fig. 1.3
Fig. 1.5
Fig. 1.4
Fig. 1.6
(A)
Fig. 1.1 Fig. 1.2
INSTALLATION INSTRUCTIONS
DASH DISASSEMBLY (Center console removal)
Note: It is not possible to install the CAM1 dash kit and
aftermarket radio without removing the center console.
1. Engage the parking brake. Put the shifter all the way back.
(Fig. 1.1)
2. Pry upward and remove the center console trim. Unclip the
center console wiring harnesses and remove it. (Fig. 1.2)
3. Using a panel tool, remove the side panels of the center
console by prying the panels out and releasing the retainer
clips. (Fig. 1.3)
4. (Automatic transmission) Remove a small cover on the
front of the shifter to expose (1) torx screw. Remove the
screw and shifter. (Fig. 1.4)
(Manual transmission) Pull up on the shifter knob to
remove it.
5. Remove (4) 7mm screws securing the shifter bezel. Pull
outward on the two clips below to release it. Disconnect the
light from the panel (if equipped) and remove the shifter
bezel. Disconnect the center console wiring harness (A),
located at the back of the shifter. (Fig. 1.5)
6. Remove (2) Philips screws at the front of the center console
(one on each side, near the junction of the radio/climate
area). (Fig. 1.6)
7. Remove (4) Philips screws on the the rear sides the
console. Remove the rear cover of the center console by
gently releasing the clips that secure it. (Fig. 1.7)
8. Remove (2) Philips screws at the rear base of the center
console. (Fig. 1.8)
9. Remove the center console cover by pulling upward and
lifting it over the parking brake. (Fig. 1.9)
1