Owner's Manual

ADS-RR(SR)-TOY03-DS-IG-EN maestro.idatalink.com
ToyoTa TundRa WiTh non-JBL amP 2020
Automotive Data Solutions Inc. © 2020
3
INSTALLATION INSTRUCTIONS
STEP 1
• Unbox the aftermarket radio and locate its main harness.
• Cut and remove the front speaker wire junction connectors.
• Connect the wires shown on the next page from
aftermarket radio main harness to the TO3 T-harness
and match the wire functions (Note: Rear speaker wire
connections are not required).
• Remove the factory radio.
STEP 2
• Connect the factory harness to the TO3 T-harness.
STEP 3
• Plug the aftermarket radio harnesses into the aftermarket
radio.
• Connect the backup camera RCA cable into the
aftermarket radio (if equipped).
• Connect the auxiliary cables into the aftermarket radio (if
equipped).
• Plug the Data cable to the data port of the aftermarket
radio.
Notes
On Pioneer radio, ensure that there is nothing plugged into
the W/R port.
STEP 4
• Connect all the harnesses to the Maestro RR module then
test your installation.
2