Owner's Manual
Table Of Contents
- Install Guide
- Toyota 4 Runner With JBL 2020
- Toyota 4 Runner Without JBL 2020
- Toyota Avalon With JBL 2019-2020
- Toyota Avalon Without JBL 2019-2020
- Toyota C-HR With CarPlay With JBL 2018
- Toyota C-HR With CarPlay Without JBL 2018
- Toyota C-HR With JBL 2019-2020
- Toyota C-HR Without JBL 2019-2020
- Toyota Camry With JBL 2018-2020
- Toyota Camry Without JBL 2018-2020
- Toyota Corolla With JBL 2020
- Toyota Corolla Without JBL 2020
- Toyota Highlander With JBL 2020
- Toyota Highlander Without JBL 2020
- Toyota Rav4 With JBL 2019-2020
- Toyota Rav4 Without JBL 2019-2020
- Toyota Sequoia With JBL 2020
- Toyota Sequoia Without JBL 2020
- Toyota Sienna With JBL 2018-2020
- Toyota Sienna Without JBL 2018-2020
- Toyota Tacoma With JBL 2020
- Toyota Tacoma Without JBL 2020
- Toyota Tundra With JBL 2020
- Toyota Tundra With Non-JBL Amp 2020
- Toyota Tundra Without JBL 2020
ADS-RR(SR)-TOY03-DS-IG-EN maestro.idatalink.com
ToyoTa Sienna WiTh JBL 2018-2020
Automotive Data Solutions Inc. © 2020
3
INSTALLATION INSTRUCTIONS
STEP 1
• Unbox the aftermarket radio and locate its main harness.
• Connect the wires shown on the next page from
aftermarket radio main harness to the TO3 T-harness
and match the wire functions (Note: Rear speaker wire
connections are not required).
• Remove the factory radio.
STEP 2
• Connect the factory harness to the TO3 T-harness.
STEP 3
• Plug the OBDII connector into the OBDII of the vehicle
(under driver dash).
STEP 4
• Plug the aftermarket radio harnesses into the aftermarket
radio.
• Connect the backup camera RCA cable into the
aftermarket radio (if equipped).
• Connect the auxiliary cables into the aftermarket radio (if
equipped).
• Plug the Data cable to the data port of the aftermarket
radio.
Notes
On Pioneer radio, ensure that there is nothing plugged into
the W/R port.
STEP 5
• Connect all the harnesses to the Maestro RR module then
test your installation.
3