Owner's Manual

ADS-RR(SR)-TOY01-DS-IG-EN maestro.idatalink.comAutomotive Data Solutions Inc. © 2019
3
toyota PRiuS With JBL 2010-2011
INSTALLATION INSTRUCTIONS
STEP 1
• Unbox the aftermarket radio and locate its main harness.
• Connect the wires shown on the next page from
aftermarket radio main harness to the TO1 T-harness and
match the wire functions.
• Remove the factory radio.
STEP 2
• If the vehicle is equipped with an OEM backup camera,
connect the TO1 T-harness to the backup camera harness
(see wire chart for details).
STEP 3
• Identify if your vehicle has a 20 or 28 pin secondary
connector. Assemble TO1 T-harness as shown on
wiring diagram. Connect the factory harness to the TO1
T-harness.
STEP 4
• Plug the OBDII connector into the OBDII of the vehicle,
under driver dash.
STEP 5
• Plug the aftermarket radio harnesses into the aftermarket
radio.
• Connect the backup camera RCA cable into the
aftermarket radio (if equipped).
• Connect the auxiliary RCA cables into the aftermarket radio
(if equipped).
• Connect the left front and right front low level outputs RCA
cables into the aftermarket radio.
• Plug the Data cable to the data port of the aftermarket
radio.
• Insert the Audio cable into the iDatalink 3.5 mm audio jack
of the aftermarket radio (If there is no iDatalink audio input,
connect to AUX).
Note: On Pioneer radio, ensure that there is nothing plugged
into the W/R port.
STEP 6
• Connect all the harnesses to the Maestro RR module then
test your installation.
1