Owner's Manual

ADS-RR(SR)-SUB02B-DS-IG-EN maestro.idatalink.com
SuBaRu FoReSteR With 6.5 inch ScReen and haRman KaRdon 2018
Automotive Data Solutions Inc. © 2020
3
INSTALLATION INSTRUCTIONS
STEP 1
• Unbox the aftermarket radio and locate its main harness.
• Connect the wires from aftermarket radio main harness to
the SU2 T-harness and match the wire functions.
• Remove the factory radio.
STEP 2
• Assemble the SU2 T-harness and connect it to the factory
radio harness.
• Locate the 28 pin connector on the SU2 T-harness. Cut the
Brown/Red wire (pin 9), extend and connect it to the Red
wire (pin1) of the 40 pin climate control connector. Cut the
Brown/Yellow wire (pin 10), extend and connect it to the
Blue wire (pin2) of the 40 pin climate control connector.
STEP 3
Note: Connection required if the vehicle is equipped with
Starlink telematics and a SOS button.
• Connect the BROWN Starlink wire to PINK or WHITE/BLUE
(pin 8) of the 8 pin connector behind the OEM Radio.
STEP 4
• Plug the OBDII connector into the OBDII of the vehicle,
under driver dash.
STEP 5
• Plug the aftermarket radio harnesses into the aftermarket
radio.
• Plug the AUX cable to the aftermarket radio.
• Plug the RCA cable to the aftermarket radio.
• Plug the Data cable to the data port of the aftermarket
radio.
• Insert the Audio cable into the iDatalink 3.5 mm audio jack
of the aftermarket radio (If there is no iDatalink audio input,
connect to AUX).
Note: On Pioneer radio, ensure that there is nothing plugged
into the W/R port.
STEP 6
• Connect all the harnesses to the Maestro RR module then
test your installation.
15