Owner's Manual

ADS-RR(SR)-CHR03-DS-IG-EN maestro.idatalink.comAutomotive Data Solutions Inc. © 2021
3
DoDge Durango 2014-2017
INSTALLATION INSTRUCTIONS
STEP 1
• Unbox the aftermarket radio and locate its main harness.
• Connect the wires shown on the next page from
aftermarket radio main harness to the CH3 T-harness and
match the wire functions.
STEP 2
• Determine if the vehicle has a factory amplifi er. Look for
badges on the radio, door panels and dash that indicate the
presence of an amplifi er (ex: Alpine).
If the vehicle DOES NOT have a factory amplifi er:
• Plug the female GREEN connector to the male GREEN
connector of your CH3 T-harness.
• Plug the female WHITE connector to the male WHITE
connector of your CH3 T-harness.
If the vehicle DOES have a factory amplifi er:
• Plug the female GREEN connector to the male WHITE
connector of your CH3 T-harness.
• Plug the female WHITE connector to the male GREEN
connector of your CH3 T-harness.
• Remove the factory radio.
STEP 3
• Connect the factory harness to the CH3 T-harness.
STEP 4
• Plug the aftermarket radio harnesses into the aftermarket
radio.
• Plug the Data cable to the data port of the aftermarket
radio.
• Insert the Audio cable into the iDatalink 3.5 mm audio jack
of the aftermarket radio. (If there is no iDatalink audio
input, connect to AUX).
Note: On Pioneer radio, ensure that there is nothing
plugged into the W/R port.
If the vehicle is equipped with parking sensors AND using
an Alpine radio: plug Audio cable in auxiliary input of the
radio.
STEP 5
• Connect all the harnesses to the Maestro RR module then
test your installation.
• If the vehicle is equipped with OEM parking assist, lane
departure, or other safety systems, the ACC-SP1 is
required: Plug the ACC-SP1 the Maestro RR.
If you are not using this speaker, the radio will mute when
the parking assist is active. If you are using this speaker,
the parking assist chimes will play through the external
speaker and the radio will not mute unless the settings
are changed in the radio.
1