Owner's Manual

ADS-DSR1-dFO2-AR-IG-EN maestro.idatalink.com
FORD ExPEDITION 2015-2020
Automotive Data Solutions Inc. © 2020
3
INSTALLATION INSTRUCTIONS
STEP 1
• Remove the factory radio and plug the dFO2 T-harness in
line with the radio plug.
STEP 2
• Connect the wires from the dFO2 T-harness to the
aftermarket amplifi er.
Note 1:
If you are running your own speaker wires from the
amplifi er to the speakers, this step is not necessary.
• Plug the RCA cables in the aftermarket amplifi er.
STEP 3
• Connect all the harnesses to the DSR1 module.
STEP 4
Program the OEM radio to “amplifi ed mode”.
• Close vehicle doors.
• Turn ignition ON-OFF-ON.
• Wait for radio to be completely booted.
• Set the audio source to OFF.
• Cycle the parking brake ON–OFF–ON.
• Push and hold Volume+ button on the steering wheel. The
radio screen will change to FM and will show volume 0.
Release the button.
• Screen will show Volume 10 – 20 - 30.
The DSR1 module is now locked to this particular vehicle by
VIN number.
Note: If you need to return the radio to its factory non-
amplifi ed mode, do this programming procedure and press
and hold VOL– button on the steering wheel instead. The
radio screen will change to FM and will show volume 0.
Release the button. The radio screen will show Volume (30
– 20 - 0). The de-programming sequence is complete.
The DSR1 is now unlocked from the vehicle.
CHIME ADJUSTMENT
Front chime
Set Audio source to OFF.
Activate front chime (Ex: door chime).
Adjust using the radio’s volume knob.
Rear chime
Set Audio source to OFF
Activate Rear chime (Ex: Rear parking assist)
Adjust using the radio’s volume knob
TROUBLESHOOTING TIPS:
• To reset the DSR1 module back its factory settings, turn
the key to the OFF position then disconnect all connectors
from the module. Wait 15 seconds and re-connect all the
connectors back to the module.
For technical assistance :
Call : 1-866-427-2999
E-mail : [e-mail]
Visit us at : maestro.idatalink.com/support and
www.12voltdata.com/forum/
1