Owner's Manual

ADS-RR(SR)-CHR01-AS maestro.idatalink.com
dodge dakota Base 2005-2007
Automotive Data Solutions Inc. © 2014
3
INSTALLATION INSTRUCTIONS
STEP 1
• Unbox the aftermarket radio and locate its main harness.
• Connect the wires shown on the next page from
aftermarket radio main harness to the CH2 T-harness and
match the wire functions.
STEP 2
• Connect the factory harness to the CH2 T-harness.
STEP 3
• Plug the aftermarket radio harnesses into the aftermarket
radio.
• Plug the Radio Control cable to the aftermarket radio.
STEP 4
• Connect all the harnesses to the Maestro RR module then
proceed to module setup.
The module is now ready to be used.
Insert the aftermarket radio in the dashboard housing and
test all the functionalities.
Reassemble the dashboard carefully.
TROUBLESHOOTING TIPS:
• To reset the module back its factory settings, turn the key
to the OFF position then disconnect all connectors from the
module. Press and hold the module’s programming button
and connect all the connectors back to the module. Wait,
the module’s LED will fl ash RED rapidly (this may take up
to 10 seconds). Release the programming button. Wait, the
LED will turn solid GREEN for 2 seconds.
• For technical assistance call 1-866-427-2999 or e-mail
“[e-mail]”. Visit us at “maestro.idatalink.
com/support” and “www.12voltdata.com/forum/”
1