Owner's Manual

ADS-RR(SR)-CHR01-DS maestro.idatalink.com
Jeep grand cherokee 2011-2013
Automotive Data Solutions Inc. © 2014
4
INSTALLATION INSTRUCTIONS
OPTION 2:
This option lets the aftermarket Bluetooth system handle
calls and stream Audio. To use the aftermarket Bluetooth
system:
• Scroll to the bottom of the setup screen and press FINISH
• Install the aftermarket microphone
WARNING: Aftermarket Bluetooth system If your phone is
paired to the Factory Bluetooth system you must delete the
pairing from the phone to the Factory Bluetooth system.
For more information and programming procedures, see
the aftermarket Bluetooth system and the factory Bluetooth
system owner’s manuals.
The module is now programmed and ready to be used. To
access the new menus, press on CHRYSLER FEATURES.
Insert the aftermarket radio in the dashboard housing
and test all the functionalities. Reassemble the dashboard
carefully.
TROUBLESHOOTING TIPS:
• To reset the module back its factory settings, turn the key
to the OFF position then disconnect all connectors from the
module. Press and hold the module’s programming button
and connect all the connectors back to the module. Wait,
the module’s LED will fl ash RED rapidly (this may take up
to 10 seconds). Release the programming button. Wait, the
LED will turn solid GREEN for 2 seconds.
• For technical assistance call 1-866-427-2999 or e-mail
“[e-mail]”. Visit us at “maestro.idatalink.
com/support” and “www.12voltdata.com/forum/”
OEM BLUETOOTH SETUP
Only one Bluetooth system can be set for hands free calling.
This must be determined before installation. Both the factory
and aftermarket systems can be used for Bluetooth audio
streaming. If the aftermarket Bluetooth is chosen for hands
free calling, the aftermarket microphone must be installed in
the vehicle.
2013 Kenwood Radios:
For these radio models, the OEM Bluetooth is turned OFF by
default. To turn ON the OEM Bluetooth, insert the key into the
ignition and turn it to the ACC position. The Radio will turn on
and the setup screen will appear. Scroll to the bottom and
select the vehicle set up menu by pressing SET. Go to the
option OEM Bluetooth and select ON. Press the return arrow
then scroll to the bottom of the page select FINISH.
2014 Kenwood Radios:
For these radio models, the OEM Bluetooth is turned ON
by default. To turn OFF the OEM Bluetooth, insert the key
into the ignition and turn it to the ACC position. The radio
will turn ON and the setup screen will appear. Scroll to the
bottom and select the vehicle set up menu by pressing SET.
Go to the option OEM Bluetooth and select OFF.
2014 Alpine Radios:
For these radio models, the OEM Bluetooth is turned ON by
default. To turn OFF the OEM Bluetooth, insert the key into
the ignition and turn it to the ACC position. The radio will
turn ON and the main screen will appear. Select the settings
button, in the top right corner, then select GENERAL.
Select INTEGRATION SETUP then select HANDS FREE
CONNECTION. Two options will be available ON or OFF,
select OFF.
2014 Pioneer Radios:
For these radio models, the OEM Bluetooth is turned ON by
default. To turn OFF the OEM Bluetooth, insert the key into
the ignition and turn it to the ACC position. The radio will
turn ON and the main screen will appear. Select SETUP,
then SYSTEM SETUP, then IDATALINK SETUP and turn OEM
Bluetooth to OFF.
Note: Bluetooth audio streaming is not supported by 2014
Pioneer radios.
1