Owner's Manual

Open the center console
lid and remove the rubber
matt.
Release locking tabs and
pull the board out.
Remove plastic ends and
screws from PCB board.
Reinstall plastic ends and
screws back on new PCB
board.
Slide board back into
casing until the tabs lock
in place.
Reassemble the center
console. Mask the SD slot
with the sticker provided.
Remove the 7 screws.
Slide the cover towards
back.
Lift the cover and flip it
over.
Disconnect the plugs then
depress the 4 locking tabs
(2 on top and 2 on the bot-
tom) and push the module
forward to release it.
16
27
38
49
105
AUX
12V DC
ACC-USB-RAM
USB MEDIA HUB REPLACEMENT - TYPE 2
Instructions
en Français
Instrucciones
en Español
Type 1 instructions on reverse >