Owner's Manual

ACC-USB-RAM
USB MEDIA HUB REPLACEMENT - TYPE 1
Release locking tabs and
pull the board out.
Remove plastic ends and
screws from PCB board.
Reinstall plastic ends and
screws back on new PCB
board.
Reinsert the module and
reassemble the center
console.
Slide board back into
casing until the tabs lock
in place.
Open the center console
lid and remove the cup
holder cover.
Expose bottom of the
console by unseating the
upholstery edge and pull-
ing it down.
Pull the foam down to
expose the backside of
the media port.
Push tabs and push the
module forward to release
it.
Disconnect the plugs then
depress the 4 locking tabs
(2 on top and 2 on the bot-
tom) and push the module
forward to release it.
16
27
38
4
10
9
5
Instructions
en Français
Instrucciones
en Español
Type 2 instructions on reverse >